Jump to content

Check out what i did to my cards!!


Phantasy Dreamz

Recommended Posts

well, i was bored......:neutral:

these are just cards which i dont think i will use again..... i took some advice from the thread that talks about secret backing in a super...

 

Avian+Marshmellon Glasses

SANY4794.jpg

 

Bazoo+Marshmellon Glasses

SANY4796.jpg

 

Graverobber+Return Zombie

SANY4797.jpg

 

Clayman+Acid Rain+Marshmellon Glasses cut-out edge(flipped)

SANY4791.jpg

Link to comment
Share on other sites

thanks..

just a tip to anyone who wants to do this too..

dont used commons..... theyre paper so theyre not easy to cut out and glue

 

lol at that. ^_^

 

these certainly look awesome. this is growing more popular to do this too...

 

i certainly wouldnt do that, because i am sort of attached to my cards and wouldnt dare deface them... XD

 

anywho, great job. ;)

Link to comment
Share on other sites

well, if you actually see the real card.... its not all that kool............

like my Avian, i had to glue another card to the back because the glue soked in so bad, the card got VERY thin/weak.... and you can see that the holo at the top of the card is peeling..*ill add more glue later*

 

*thats why i say commons are not so good if youre doing this... theyre paper back

Link to comment
Share on other sites

i dont mind spreading the idea at all.......

ok........ heres how i did mine

1st...

-soaked the holo, which you like to use for the backing, in warm water. it takes about 5 min or so for the water to soaked into the card. peel the holo sheet off, it should be a thin plastic of holo. then gently rub away the extras in the back.(do this with both holos if youre planning to use two holos instead of a common, which i recommend

-for commons, use some kind of knife and split the card (it should split easily, and try not to tear any along the way), but save both pieces cause youll need to glue it back together later.

*if you need to rotate the holo backing to fit(as i did in Bazoo), then youll need to split up both images.

 

2nd...

-if the monster/figure you want doesnt touch the edges (Graverobber for ex), use an exacto knife and cut out your monster/pix of the card which you wish to holo, and glue the cut out to the holo backing as best as you can (try to cover as much of the backing as you can.) then glue the rest right on top of the not wanted card.

youll need to cut out only 1 holo if you do this (only the monster/figure of which you want to holo)

-if the monster/figure you want to holo touches the edges(Avian for ex), then all you do is cut out the backing of that monster/pix(be extremly careful with commons. dont press too hard on the knife or youll cut throught the card). then cut out the square image which you want for the backing, and glue your monster/figure which you want to holo on the backing.

 

well thats how i did mines... yea it took me all night just to make those four..........

if you didnt understand that, then i cant help you.. English is not my primary language... sorry

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Guest
This topic is now closed to further replies.
×
×
  • Create New...